A general contractor in New York doing some work at the WTC figured there had to be a solution to the problem at hand. In the basement where 2 elevator doors open there is a drop off to the floor below. Often equipment and personnel are needed in this area to go to other parts of the building. Having to use the stairs to lug equipment and other products up and down was becoming very cumbersome and potentially dangerous.
They turned to ATI for the solution and as they normally do, ATI had the perfect product for their application. The Zero-Low Dock Lift Table was the answer. This lift table allowed them the ability to transfer virtually whatever they wanted to. Whether that be equipment, products, and/or people. The tricky part in the contractors eyes was the with the limited space available for the second lift table. Again, ATI had the answer. Air Technical Industries does modified and custom work and they were able to perfectly fit the right size unit in the space available.
The Zero-Low Dock Lift Table allows you to work from different elevations for easy raising and lowering of loads. Ground-zero loading without the need for ramps or cumbersome inclines. Easy and convenient to drive on to with a pallet truck, forklift, or roll on loads then lift from one elevation to another. This saves the expense and inconvenience of pit mounting and offers the versatility to be used any place on a solid floor for easy loading and unloading. Capacities range from 4,000 pounds to 50,000 pounds and above. Here is a link for the Zero Low Dock Lift Table for your convenience https://www.airtechnical.com/product/zero-low-dock-lift/.